Load modules, in this case kvm of intel cpu;
# modprobe -a kvm-intel tun virtio
Add users to kvm group;
# usermod -a -G kvm c9admin
# usermod -a -G kvm username
Create hard disk image, there is different types, this describes how to create a qcow2 type;
$ qemu-img create -f qcow2 crux-img.qcow2 15G
You can mount disk image;
$ sudo modprobe nbd
$ sudo qemu-nbd -c /dev/nbd0 /crux-img.qcow2
To disconnect image disk (ndb);
$ sudo qemu-nbd -d /dev/nbd0
Information about preparing partitions and storage administration. You can use image as a normal disk, example how to use parted to create a gpt system table;
# parted /dev/nbd0
(parted) mklabel gpt
(parted) mkpart ext4 0% 100%
(parted) set 1 boot on
# kpartx -a -s -l -u /dev/nbd0
# mkfs.ext4 /dev/mapper/nbd0p1
Mount partition;
# mount /dev/mapper/nbd0p1
Network configuration;
KERNEL=="tun", GROUP="kvm", MODE="0660", OPTIONS+="static_node=net/tun"
Create bridge, create new tap and add it to bridge;
# DEV="br0"
# TAP="tap5"
# ip tuntap add ${TAP} mode tap group kvm
# ip link set ${TAP} up
# ip link set ${TAP} master ${DEV}
See scripts/system-qemu.sh, as template. Run virtual machine that uses above tap device;
$ ISO=~/crux-3.2.iso
$ IMG=~/crux-img.qcow2
$ qemu-system-x86_64 \
-enable-kvm \
-m 1024 \
-boot d \
-cdrom ${ISO} \
-hda ${IMG} \
-net nic,model=virtio -net tap,ifname=${TAP},script=no,downscript=no
Create interface with correct permissions set for kvm group.
# sysctl -w net.ipv4.ip_forward=1
# iptables -t nat -A POSTROUTING -s 10.0.0.0/24 -o eth0 -j MASQUERADE
Start qemu with 512 of ram, mydisk.img as disk and boot from iso
$ ISO=~/crux-3.2.iso
$ IMG=~/crux-img.qcow2
$ qemu-system-x86_64 \
-enable-kvm \
-m 1024 \
-boot d \
-cdrom ${ISO} \
-hda ${IMG} \
-net nic,model=virtio -net tap,ifname=${TAP},script=no,downscript=no
Tools Index
This is part of the c9 Manual. Copyright (C) 2016 c9 team. See the file Gnu Free Documentation License for copying conditions.