Load modules, in this case kvm of intel cpu;
# modprobe -a kvm-intel tun virtio
Add users to kvm group;
# usermod -a -G kvm c9admin
# usermod -a -G kvm username
Create hard disk image, there is different types, this describes how to create a qcow2 type;
$ qemu-img create -f qcow2 crux-img.qcow2 15G
You can mount disk image;
$ sudo modprobe nbd
$ sudo qemu-nbd -c /dev/nbd0 /crux-img.qcow2
To disconnect image disk (ndb);
$ sudo qemu-nbd -d /dev/nbd0
Information about preparing partitions and storage administration. You can use image as a normal disk, example how to use parted to create a gpt system table;
# parted --script $DEV \
mklabel gpt \
mkpart ESP fat32 1MiB 120MiB \
mkpart primary ext4 120MiB 720MiB \
mkpart primary ext4 720MiB 2720MiB \
mkpart primary ext4 2720MiB 5000MiB \
set 1 boot on
# kpartx -a -s -l -u /dev/nbd0
Use /dev/mapper/$(name_of_device) to assign correct blocks;
# mkfs.fat -F 32 $BLK_EFI
# mkfs.ext4 $BLK_BOOT
# mkfs.ext4 $BLK_ROOT
# mkfs.ext4 $BLK_VAR
Mount partition;
# mount $BLK_ROOT $CHROOT
# mkdir -p $CHROOT/boot
# mount $BLK_BOOT $CHROOT/boot
# mkdir -p $CHROOT/boot/efi
# mount $BLK_EFI $CHROOT/boot/efi
# mkdir -p $CHROOT/var
# mount $BLK_VAR $CHROOT/var
Network configuration;
KERNEL=="tun", GROUP="kvm", MODE="0660", OPTIONS+="static_node=net/tun"
Create bridge, create new tap and add it to bridge;
# DEV="br0"
# TAP="tap1"
# ip tuntap add ${TAP} mode tap group kvm
# ip link set ${TAP} up
# ip link set ${TAP} master ${DEV}
Create interface with correct permissions set for kvm group.
# sysctl -w net.ipv4.ip_forward=1
# iptables -t nat -A POSTROUTING -s 10.0.0.0/24 -o eth0 -j MASQUERADE
Start qemu with 512 of ram, mydisk.img as disk and boot from iso
See scripts/system-qemu.sh, as template. Run virtual machine that uses above tap device;
$ ISO=~/crux-3.2.iso
$ IMG=~/crux-img.qcow2
$ TAP="tap1"
$ qemu-system-x86_64 \
-enable-kvm \
-m 1024 \
-boot d \
-cdrom ${ISO} \
-hda ${IMG} \
-net nic,model=virtio -net tap,ifname=${TAP},script=no,downscript=no
$ ISO=~/crux-3.2.iso
$ IMG=~/crux-img.qcow2
$ qemu-system-x86_64 \
-enable-kvm \
-m 1024 \
-boot d \
-cdrom ${ISO} \
-hda ${IMG} \
-net nic,model=virtio -net tap,ifname=${TAP},script=no,downscript=no
Tools Index
This is part of the c9 Manual. Copyright (C) 2016 c9 team. See the file Gnu Free Documentation License for copying conditions.